My Cart

XBee ZB UFL Module + Pigtail

34 €34.00

Availability: On Demand

XBee ZB embedded RF modules provide cost-effective wireless connectivity to devices in ZigBee mesh networks. UFL Antenna Module

It includes a pigtail to use with our 2dBi or 5dBi antennas.

Note: If you are searching for Wireless Sensor Networks devices (motes) you may be interested in our ready to market sensor platform: Waspmote. You can discover the differences between both platforms in the document: Waspmote vs SquidBee.

Qty:
Add to Compare

Description

XBee ZB embedded RF modules provide cost-effective wireless connectivity to devices in ZigBee mesh networks. UFL Antenna Module

Performance

RF Data Rate 250 Kbps
Indoor/Urban Range 133 ft (40 m)
Outdoor/RF Line-of-Sight Range  
400 ft (120 m)
Transmit Power 1.25 mW (+1 dBm) / 2 mW (+3 dBm) boost mode
Receiver Sensitivity (1% PER) -96 dBm in boost mode

Features

Adjustable Power Yes
I/O Interface 3.3V CMOS UART, ADC, DIO
Configuration Method API or AT commands, local or over-the-air
Frequency Band 2.4 GHz
Interference Immunity DSSS (Direct Sequence Spread Spectrum)
Serial Data Rate 1200 bps - 1 Mbps
ADC Inputs (4) 10-bit ADC inputs
Digital I/O 10
Antenna Options Chip, Wire Whip, U.FL, RPSMA
Operating Temperature
& Humidity
-40° C to +85° C, 0-95% humidity non-condensing

Programmability

Networking & Security
Encryption 128-bit AES
Reliable Packet Delivery Retries/Acknowledgments
IDs and Channels PAN ID, 64-bit IEEE MAC, 16 channels

Power Requirements

Supply Voltage 2.1 - 3.6VDC
Transmit Current 35 mA / 45 mA boost mode @ 3.3VDC
Receive Current 38 mA / 40 mA boost mode @ 3.3VDC
Power-Down Current <1 uA @ 25º C

Regulatory Approvals

FCC (USA) Yes
IC (Canada) Yes
ETSI (Europe) Yes
C-TICK (Australia) Yes
TELEC (Japan) Yes

Note: If you are searching for Wireless Sensor Networks devices (motes) you may be interested in our ready to market sensor platform: Waspmote. You can discover the differences between both platforms in the document: Waspmote vs SquidBee.

Related Tutorials

The Multiprotocol Radio Shield is an interconnection shield for Arduino, and was designed to connect two communication modules at the same time. This that means a lot of possibilities and applications can be made using the cooking-hacks modules.

The Multiprotocol Radio Shield includes the SPI bus connections that allows the use of the RS-485 and CAN Bus modules, but also is compatible with the rest of the cooking-hacks modules as RFID, XBee and Bluetooth.

The Arduino XBee shield allows your Arduino board to communicate wirelessly using Zigbee. It was developed in collaboration with Arduino. This documentation describes the use of the shield with the XBee module.

It is also compatible with Raspberry Pi using the Raspberry Pi to Arduino shields connection bridge.

If you are interested in Internet of Things (IoT) or M2M projects check our open source sensor platform Waspmote which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.

Know more at:

Get the Starter Kits at: