XBee-PRO ZB embedded RF modules provide cost-effective wireless connectivity to devices in ZigBee mesh networks. Utilizing the ZigBee PRO Feature Set, these modules are interoperable with other ZigBee devices, including devices from other vendors. Programmable versions of the XBee-PRO ZB module make customizing ZigBee applications easy, even without wireless design expertise. SMA-RP Version.
|RF Data Rate||250 Kbps|
|Indoor/Urban Range||300 ft. (90 m)|
|Outdoor/RF Line-of-Sight Range||Int’l 5000 ft (1500 m)|
|Transmit Power||Int’l 10 mW (+10 dBm)|
|Receiver Sensitivity (1% PER)||-102 dBm|
|I/O Interface||3.3V CMOS UART, SPI, I2C, PWM, DIO, ADC|
|Configuration Method||API or AT commands, local or over-the-air|
|Frequency Band||2.4 GHz|
|Interference Immunity||DSSS (Direct Sequence Spread Spectrum)|
|Serial Data Rate||1200 bps - 1 Mbps|
|ADC Inputs||(4) 10-bit ADC inputs|
|-40° C to +85° C, 0-95% humidity non-condensing|
|Memory||32 KB Flash / 2 KB RAM)|
|CPU/Clock Speed||HCS08 / Up to 50.33 MHz|
Networking & Security
|Reliable Packet Delivery||Retries/Acknowledgments|
|IDs and Channels||PAN ID, 64-bit IEEE MAC, 15 channels|
|Supply Voltage||2.7 - 3.6VDC|
|Transmit Current||205 mA|
|Receive Current||47 mA|
|Power-Down Current||3.5 uA @ 25º C|
Note: If you are searching for Wireless Sensor Networks devices (motes) you may be interested in our ready to market sensor platform: Waspmote. You can discover the differences between both platforms in the document: Waspmote vs SquidBee.
The Arduino XBee shield allows your Arduino board to communicate wirelessly using Zigbee. It was developed in collaboration with Arduino. This documentation describes the use of the shield with the XBee module.
It is also compatible with Raspberry Pi using the Raspberry Pi to Arduino shields connection bridge.
The Multiprotocol Radio Shield is an interconnection shield for Arduino, and was designed to connect two communication modules at the same time. This that means a lot of possibilities and applications can be made using the cooking-hacks modules.
The Multiprotocol Radio Shield includes the SPI bus connections that allows the use of the RS-485 and CAN Bus modules, but also is compatible with the rest of the cooking-hacks modules as RFID, XBee and Bluetooth.
The current tutorial explains how to take the most of the Galileo board by using on it the Arduino and Raspberry Pi shields and modules designed by Cooking Hacks
Galileo comes with a single-core 32-bit, 400MHz Quark SoC X1000 processor, supports 3.3 or 5 volt shields and has an Ethernet and USB port. Compatible with Windows, Mac OS and Linux, the software of Galileo also has support for the Arduino shield ecosystem.
The idea behind the Raspberry Pi to Arduino shields connection bridge is to allow to use any of the shields, boards and modules designed for Arduino in Raspberry Pi.
It includes also the possibility of connecting digital and analog sensors, using the same pinout of Arduino but with the power and capabilities of Raspberry.
If you are interested in Internet of Things (IoT) or M2M projects check our open source sensor platform Waspmote which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.
Know more at:
Get the Starter Kits at: