XBee-PRO 900HP embedded modules provide best-in-class range wireless connectivity to devices. They take advantage of the DigiMeshÂ® networking protocol, featuring dense network operation and support for sleeping routers, and are also available in a proprietary point-to-multipoint configuration. Supporting RF line-of-sight ranges up to 28 miles (with high-gain antennas), and data rates of up to 200 Kbps, these modules are ideal for extended-range applications requiring increased data throughput. Â The XBee-PRO 900HP requires no programming and can be configured easily using Digiâ€™s free X-CTU software or via a simplified AT command set. XBee modules are pre-certified for use in multiple countries, further reducing development costs and time to market. Â XBeeÂ® modules are easy to use, share a common hardware footprint and are available in a variety of different protocols, enabling users to substitute one XBee for another with minimal development time and risk. Feature: Superior outdoor LOS range of up to 28 miles with high-gain antenna Simplified AT command set or advanced XBee API accelerates time to market Over-the-air firmware updates via other XBee-PRO 900HP modules or Device Cloud by Etheriosâ„¢ Software-selectable channel mask for interference immunity Advanced sleep modes include sleeping routers, pin sleep, cyclic sleep Â Hardware: Processor: ADF7023 transceiver, Cortex-M3 EFM32G230 @ 28 MHz Frequency Band: 902 to 928 MHz, software selectable channel mask for interference immunity Antenna Options: Wire, U.FL and RPSMA Â RF Data Rate: 10 Kbps or 200 Kbps Indoor/Urban Range: 10 Kbps: up to 2000 ft (610 m); 200 Kbps: up to 1000 ft (305 m) Outdoor/ Line-Of-Sight Range : 10 Kbps: up to 9 miles (14 km); 200 Kbps: up to 4 miles (6.5 km) ( w/ 2.1 dB dipole antennas) Transmit Power: Up to 24 dBm (250 mW) software selectable Receiver Sensitivity: -101 dBm @ 200 Kbps, -110 dBm @ 10 Kbps Â Data Interface: UART (3V), SPI GPIO: Up
The Multiprotocol Radio Shield is an interconnection shield for Arduino, and was designed to connect two communication modules at the same time. This that means a lot of possibilities and applications can be made
using the cooking-hacks modules.
The Multiprotocol Radio Shield includes the SPI bus connections that allows the use of the RS-485 and CAN Bus modules, but also is compatible with the rest of the cooking-hacks modules as RFID, XBee and Bluetooth.
The Arduino XBee shield allows your Arduino board to communicate wirelessly using Zigbee. It was developed in collaboration with Arduino. This documentation describes the use of the shield with the XBee module.
It is also compatible with Raspberry Pi using the Raspberry Pi to Arduino shields connection bridge.
If you are interested in Internet of Things (IoT) or M2M projects check our open
source sensor platform Waspmote
which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.
Know more at:
Get the Starter Kits at: