XBee-PRO 868 modules are long-range embedded RF modules providing end-point device connectivity for European applications. Supporting RF line-of-sight distances up to 80 km, these modules are ideal for challenging wireless environments where RF penetration and transmission distance are critical to the application. Only for use in EUROPE. SMA-RP Version.
Note: This item is not intended for Waspmote, check this kit instead.
|RF Data Rate||24 Kbps (limited to 10% duty cycle)|
|Indoor/Urban Range||Up to 1800 ft (550 m)|
|Outdoor/RF Line-of-Sight Range||Up to 25 miles (40 km) with dipole antenna
Up to 10 miles (16 km) with dipole antenna (13.7 dBm) - Italy only
|Transmit Power||1 mW (0 dBm) to 315 mW (+25 dBm)|
|Receiver Sensitivity (1% PER)||-112 dBm|
|Serial Data Interface||3.3V CMOS Serial UART|
|Configuration Method||API and AT commands|
|Frequency Band||868 MHz ISM|
|Interference Immunity||Multiple transmissions, acknowledgements|
|Serial Data Rate||1.2 Kbps to 230.4 Kbps (nonstandard rates available)|
|ADC Inputs||Coming in future firmware revisions|
|Digital I/O||Coming in future firmware revisions|
Networking & Security
|Reliable Packet Delivery||Retries/Acknowledgments|
|Addressing Options||Network ID, 32-bit address|
|Supply Voltage||3.0 – 3.6 VDC|
|Transmit Current||500 mA typical at 3.3V (800 mA max)|
|Receive Current||65 mA typical|
|Power-Down Current||Coming in future firmware revisions|
|ETSI (Europe)||Yes (Italy 25 mW max)|
ļ»æNote: If you are searching for Wireless Sensor Networks devices (motes) you may be interested in our ready to market sensor platform: Waspmote. You can discover the differences between both platforms in the document: Waspmote vs SquidBee.
The Arduino XBee shield allows your Arduino board to communicate wirelessly using Zigbee. It was developed in collaboration with Arduino. This documentation describes the use of the shield with the XBee module.
It is also compatible with Raspberry Pi using the Raspberry Pi to Arduino shields connection bridge.
The Multiprotocol Radio Shield is an interconnection shield for Arduino, and was designed to connect two communication modules at the same time. This that means a lot of possibilities and applications can be made using the cooking-hacks modules.
The Multiprotocol Radio Shield includes the SPI bus connections that allows the use of the RS-485 and CAN Bus modules, but also is compatible with the rest of the cooking-hacks modules as RFID, XBee and Bluetooth.
If you are interested in Internet of Things (IoT) or M2M projects check our open source sensor platform Waspmote which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.
Know more at:
Get the Starter Kits at: