This is the fantastically easy to use sensor from Maxbotix. We are extremely pleased with the size, quality, and ease of use of this little range finder. The serial interface is a bit odd (itâ€™s RS232 instead of standard TTL), but the PWM and Analog interfaces will allow any micro to listen easily enough. The sensor provides very accurate readings of 0 to 255 inches (0 to 6.45m) in 1 inch increments with little or no dead zone! Maxbotix is offering the EZ0, EZ1, EZ2, EZ3, and EZ4 with progressively narrower beam angles allowing the sensor to match the application. Please see beam width explanation below. Control up to 10 sensors with only two pins! Checkout the Maxbotix EZ1 FAQ listed below.Features:42kHz Ultrasonic sensorOperates from 2.5-5.5VLow 2mA supply current20Hz reading rateRS232 Serial Output - 9600bpsAnalog Output - 10mV/inchPWM Output - 147uS/inchSmall, light weight moduleDocuments:DatasheetBeam Width ExplanationMaxbotix EZ1 FAQSensor Selection Guide Checkout Mikey Sklarâ€™s flame-based trampoline, the high-lighter, using the EZ1!
If you are interested in Internet of Things (IoT) or M2M projects check our open
source sensor platform Waspmote
which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.
Know more at:
Get the Starter Kits at: