This is a very simple board that takes a 6-12V input voltage and outputs a selectable 5V or 3.3V regulated voltage. All headers are 0.1" pitch for simple insertion into a breadboard. Input power can be supplied to either the DC barrel jack or the two pin header labeled + and -. Output power is supplied to the pins labeled GND and VCC. Board has both an On/Off switch and a voltage select switch (3.3V/5V). The two sets of four GND and VCC holes are spaced such that when connected to our Basic Breadboard both power busses will be powered.Note: Headers are not supplied. You will need to supply your own headers to connect this board to a breadboard. Check below for some breakaway header strips.Dimensions: 2.15x0.65"Features:6-12V input voltage via barrel jack or 2-pin header3.3V or 5V regulated output voltage800mA Operating CurrentON/OFF switchOutput voltage select switchPower status LEDPTC fuse protected power5.5x2.1mm center positive barrel jackDocuments:SchematicEagle FilesUnregulated Power Supply TutorialGitHub (Design Files)
If you are interested in Internet of Things (IoT) or M2M projects check our open
source sensor platform Waspmote
which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.
Know more at:
Get the Starter Kits at: