My Cart

SparkFun Barometric Pressure Sensor Breakout - BMP180

9.95 €9.95

Availability: Retired

This is a breakout board for the Bosch BMP180 high-precision, low-power digital barometer. The BMP180 offers a pressure measuring range of 300 to 1100 hPa with an accuracy down to 0.02 hPa in advanced resolution mode. It’s based on piezo-resistive technology for high accuracy, ruggedness and long term stability. These come factory-calibrated, with the calibration coefficients already stored in ROM. What makes this sensor great is that it is nearly identical to its former rev, the BMP085! This breadboard-friendly board breaks out every pin to a 5-pin 0.1" pitch header. VCC can be from 1.8V to 3.6V and is I/O lines are 5V tolerant; we typically run it on a clean, regulated 3.3V supply. The analog and digital supplies (VDDD and VDDA) are tied to a single header pin, but are separately decoupled. It connects to a microcontroller via I²C bus (also known as TWI, or on the Arduino, the “Wire” library).Features:Digital two wire (I²C, TWI, “Wire”) interfaceWide barometric pressure rangeFlexible supply voltage range (1.8V to 3.6V)Ultra-low power consumptionLow noise measurementsFactory-calibratedIncludes temperature sensorLow-profile with a small footprintDocuments:SchematicEagle FilesDatasheet (BMP180)Quickstart GuideGitHub

Description

This is a breakout board for the Bosch BMP180 high-precision, low-power digital barometer. The BMP180 offers a pressure measuring range of 300 to 1100 hPa with an accuracy down to 0.02 hPa in advanced resolution mode. It’s based on piezo-resistive technology for high accuracy, ruggedness and long term stability. These come factory-calibrated, with the calibration coefficients already stored in ROM. What makes this sensor great is that it is nearly identical to its former rev, the BMP085! This breadboard-friendly board breaks out every pin to a 5-pin 0.1" pitch header. VCC can be from 1.8V to 3.6V and is I/O lines are 5V tolerant; we typically run it on a clean, regulated 3.3V supply. The analog and digital supplies (VDDD and VDDA) are tied to a single header pin, but are separately decoupled. It connects to a microcontroller via I²C bus (also known as TWI, or on the Arduino, the “Wire” library).Features:Digital two wire (I²C, TWI, “Wire”) interfaceWide barometric pressure rangeFlexible supply voltage range (1.8V to 3.6V)Ultra-low power consumptionLow noise measurementsFactory-calibratedIncludes temperature sensorLow-profile with a small footprintDocuments:SchematicEagle FilesDatasheet (BMP180)Quickstart GuideGitHub

If you are interested in Internet of Things (IoT) or M2M projects check our open source sensor platform Waspmote which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.

Know more at:

Get the Starter Kits at: