My Cart

Sharp GP2Y1010AU0F Compact optical Dust Sensor

10.15 €10.15

Availability: On Demand

Introduction

The Sharp Optical Dust Sensor (GP2Y1010AU0F) is especially effective in detecting very fine particles like cigarette smoke, and is commonly used in air purifier systems.
An infrared emitting diode and a phototransistor are diagonally arranged into this device, to allow it to detect the reflected light of dust in air.
The sensor has a very low current consumption (20mA max, 11mA typical), and can be powered with up to 7VDC. The output of the sensor is an analog voltage proportional to the measured dust density, with a sensitivity of 0.5V/0.1mg/m3.
For your convenience, DFRobot ship this sensor with a 6-pin, 1.5mm pitch mating connector and cable.
To link this sensor with Arduino, a 150ohm resistor and a 220uF capacitor are required.
Specification
  • Supply voltage: 5-7V
  • Operating temperature: -10-65 Celsius degree
  • Consumption current:20mA max
Shipping List
  • Sharp GP2Y1010AU0F Dust Sensor *1
  • Cable *1
Documents
Qty:
Add to Compare

Description

Introduction

The Sharp Optical Dust Sensor (GP2Y1010AU0F) is especially effective in detecting very fine particles like cigarette smoke, and is commonly used in air purifier systems.
An infrared emitting diode and a phototransistor are diagonally arranged into this device, to allow it to detect the reflected light of dust in air.
The sensor has a very low current consumption (20mA max, 11mA typical), and can be powered with up to 7VDC. The output of the sensor is an analog voltage proportional to the measured dust density, with a sensitivity of 0.5V/0.1mg/m3.
For your convenience, DFRobot ship this sensor with a 6-pin, 1.5mm pitch mating connector and cable.
To link this sensor with Arduino, a 150ohm resistor and a 220uF capacitor are required.
Specification
  • Supply voltage: 5-7V
  • Operating temperature: -10-65 Celsius degree
  • Consumption current:20mA max
Shipping List
  • Sharp GP2Y1010AU0F Dust Sensor *1
  • Cable *1
Documents

If you are interested in Internet of Things (IoT) or M2M projects check our open source sensor platform Waspmote which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.

Know more at:

Get the Starter Kits at: