My Cart

Raspberry Pi - Model B+ Enclosure (Clear)

8.95 €8.95

Availability: Retired

The Raspberry Pi Model B+ is THE new favorite of development platforms, so the last thing that youd want is for something bad to happen to it. Why not protect it with one of these snazzy clear plastic enclosures? These translucent cases protect the B+ from things like rogue wires that might short it out while still allowing full access to the board as well as proper airflow to keep your new toy cool! Simply snap the RPi B+ into the bottom half of the enclosure, then snap the two sides together.

The enclosure provides slots to access the GPIO header, USB ports, Ethernet, microSD card, HMDI, 3.5mm jack, and CSI connectors as well as rubber feet and vents to ensure the board gets proper cooling and Pi Camera module mounting holes. All of the status LEDs on the Pi are visible through the case thanks to tunnel recesses embedded in the design and the two piece case can be taken apart without unplugging any cables. This is a really slick case and once youve gotten your hands on a Raspberry Pi, youll want to snag one of these to put it in!

Note: This case does NOT include a Raspberry Pi Model B+.

Dimensions: 93.4mm x 62.7mm x 31.1mm

Documents:

Description

The Raspberry Pi Model B+ is THE new favorite of development platforms, so the last thing that youd want is for something bad to happen to it. Why not protect it with one of these snazzy clear plastic enclosures? These translucent cases protect the B+ from things like rogue wires that might short it out while still allowing full access to the board as well as proper airflow to keep your new toy cool! Simply snap the RPi B+ into the bottom half of the enclosure, then snap the two sides together.

The enclosure provides slots to access the GPIO header, USB ports, Ethernet, microSD card, HMDI, 3.5mm jack, and CSI connectors as well as rubber feet and vents to ensure the board gets proper cooling and Pi Camera module mounting holes. All of the status LEDs on the Pi are visible through the case thanks to tunnel recesses embedded in the design and the two piece case can be taken apart without unplugging any cables. This is a really slick case and once youve gotten your hands on a Raspberry Pi, youll want to snag one of these to put it in!

Note: This case does NOT include a Raspberry Pi Model B+.

Dimensions: 93.4mm x 62.7mm x 31.1mm

Documents:

If you are interested in Internet of Things (IoT) or M2M projects check our open source sensor platform Waspmote which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.

Know more at:

Get the Starter Kits at: