This is a 4" long Expansion Cable for the MiP Robotic Platform. Inside each MiP is a small 4-pin JST connector attached to its main board, with this cable you will be able to connect directly into the robots UART port and access itâ€™s hacking interface with your preferred dev board. Each expansion cable features a 1.5mm pitch and fits very tight to reduce its chances of coming loose during operation.Note: You will need to drill a small hole into the back of your MiP to run this cable to a dev board or proto pack.Documents:Datasheet
If you are interested in Internet of Things (IoT) or M2M projects check our open
source sensor platform Waspmote
which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.
Know more at:
Get the Starter Kits at: