My Cart

Mini Touch Kit

6.25 €6.25

Availability: On Demand

Introduction

This is a cool touch sensor from DFRobot. You can hook it up to the IO Expansion shield (for arduino) directly. It includes a metallic tape with a sticky side. This make it possible for you to place your sensors anywhere you want. So, if you get sick of the typical push buttons, try this invisible button for your projects! This touch sensor works on a variety of surfaces; Metal, glass, plastic, rubber. It does not work on cardboard or wood.
NOTE:This sensor requires some basic soldering.
Specification
  • Power supply: 3.3-5v
  • Pin definition:
    • Digital output(Green wire)
    • Power(Red wire)
    • GND(Black wire)
Shipping List
  • ITA-Touch module with Digital sensor cable(1 unit)
  • 3x3cm copper with the sticky part(1 unit)
  • 15cm wire(1 unit)
Documents
Qty:
Add to Compare

Description

Introduction

This is a cool touch sensor from DFRobot. You can hook it up to the IO Expansion shield (for arduino) directly. It includes a metallic tape with a sticky side. This make it possible for you to place your sensors anywhere you want. So, if you get sick of the typical push buttons, try this invisible button for your projects! This touch sensor works on a variety of surfaces; Metal, glass, plastic, rubber. It does not work on cardboard or wood.
NOTE:This sensor requires some basic soldering.
Specification
  • Power supply: 3.3-5v
  • Pin definition:
    • Digital output(Green wire)
    • Power(Red wire)
    • GND(Black wire)
Shipping List
  • ITA-Touch module with Digital sensor cable(1 unit)
  • 3x3cm copper with the sticky part(1 unit)
  • 15cm wire(1 unit)
Documents

If you are interested in Internet of Things (IoT) or M2M projects check our open source sensor platform Waspmote which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.

Know more at:

Get the Starter Kits at: