The elbow hinge allows beams to pivot on the edge of the profile with about 180 degrees of rotation. In other words, at fully-closed the two beams will be parallel to each other. The bushing that connects the joint works with a 3mm OD shaft if you want to run a shaft through several joints.
We are selling these as single joints so you'll need two of these to make a full elbow (one per side).
If you are interested in Internet of Things (IoT) or M2M projects check our open source sensor platform Waspmote which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.
Know more at:
Get the Starter Kits at: