Cooking Hacks Forum
https://www.cooking-hacks.com/forum/

Error after making commandline.txt changes for PI3 shield
https://www.cooking-hacks.com/forum/viewtopic.php?f=44&t=8734
Page 1 of 1

Author:  dcvice1967 [ Thu Apr 28, 2016 7:35 pm ]
Post subject:  Error after making commandline.txt changes for PI3 shield

I am trying to setup my PI 3 to use the arduino shield. When I Make the change below and reboot the system boot fails stating it cannot mount the file system. I believe the issue has to do with the
root file system location "root=/dev/mmcblk0p2" which is different form what was there before the change. Can you confirm whether this value is correct?

3.3 Using ArduPi library in Raspberry Pi 3:

Exit and save.
Change the file /boot/cmdline.txt to the following:
dwc_otg.lpm_enable=0 console=serial1,115200 console=tty1 root=/dev/mmcblk0p2 kgdboc=serial1,115200 rootfstype=ext4 elevator=deadline fsck.repair=yes rootwait
Select all

Author:  libelium-dev [ Tue May 03, 2016 7:26 am ]
Post subject:  Re: Error after making commandline.txt changes for PI3 shiel

Hello dcvive1967,
What distribution of operating system are you using?. We are tested these steps in RASPBIAN JESSIE. Anyway we will test the latest distribution.
Regards.

Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/