Post a new topicPost a reply Page 1 of 1   [ 2 posts ]
Author Message
 Post subject: Error after making commandline.txt changes for PI3 shield
PostPosted: Thu Apr 28, 2016 7:35 pm 

Joined: Mon Apr 18, 2016 9:08 pm
Posts: 4
I am trying to setup my PI 3 to use the arduino shield. When I Make the change below and reboot the system boot fails stating it cannot mount the file system. I believe the issue has to do with the
root file system location "root=/dev/mmcblk0p2" which is different form what was there before the change. Can you confirm whether this value is correct?

3.3 Using ArduPi library in Raspberry Pi 3:

Exit and save.
Change the file /boot/cmdline.txt to the following:
dwc_otg.lpm_enable=0 console=serial1,115200 console=tty1 root=/dev/mmcblk0p2 kgdboc=serial1,115200 rootfstype=ext4 elevator=deadline fsck.repair=yes rootwait
Select all


Top
 Profile  
 
 Post subject: Re: Error after making commandline.txt changes for PI3 shiel
PostPosted: Tue May 03, 2016 7:26 am 

Joined: Mon Sep 28, 2009 12:06 pm
Posts: 11285
Hello dcvive1967,
What distribution of operating system are you using?. We are tested these steps in RASPBIAN JESSIE. Anyway we will test the latest distribution.
Regards.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post a new topicPost a reply Page 1 of 1   [ 2 posts ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
cron


Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
Libelium theme based on 610nm Style by Daniel St. Jules of http://www.gamexe.net


© Libelium Comunicaciones Distribuidas S.L. | Terms of use.