| Cooking Hacks Forum https://www.cooking-hacks.com/forum/ |
|
| Setting up Marlin https://www.cooking-hacks.com/forum/viewtopic.php?f=40&t=4263 |
Page 1 of 1 |
| Author: | CEN [ Sun Nov 17, 2013 11:55 pm ] |
| Post subject: | Setting up Marlin |
In the Marlin setup instructions there is a section that is highlighted # define TEMP_SENSOR_0 1 # define TEMP_SENSOR_1 1 # define TEMP_SENSOR_2 1 # define TEMP_SENSOR_BED 1 Yet in the text #define TEMP_SENSOR_0 7 #define TEMP_SENSOR_1 0 #define TEMP_SENSOR_2 0 #define TEMP_SENSOR_BED 1 and discusses "Depending of your Hot End, you will select one sensor or other." I have http://www.cooking-hacks.com/shop/3d-pr ... e-extruder Is this the correct setting for this nozzle/sensor ? It also mentions "const bool X_ENDSTOPS_INVERTING = true" etc I have not found X_ENDSTOPS_INVERTING in the current Marlin.pde file Is this an addition , or out of date documentation ? Any help appreciated in advance . CEN |
|
| Author: | libelium-dev [ Mon Nov 18, 2013 8:53 am ] |
| Post subject: | Re: Setting up Marlin |
Hello CEN, Post in our community category. If the community knows how to help you with your questions we will be glad to hear about it. Regards. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|