Cooking Hacks Forum

Setting up Marlin
Page 1 of 1

Author:  CEN [ Sun Nov 17, 2013 11:55 pm ]
Post subject:  Setting up Marlin

In the Marlin setup instructions there is a section that is highlighted
# define TEMP_SENSOR_0 1
# define TEMP_SENSOR_1 1
# define TEMP_SENSOR_2 1
# define TEMP_SENSOR_BED 1

Yet in the text

#define TEMP_SENSOR_0 7
#define TEMP_SENSOR_1 0
#define TEMP_SENSOR_2 0
and discusses "Depending of your Hot End, you will select one sensor or other."

I have ... e-extruder

Is this the correct setting for this nozzle/sensor ?

It also mentions "const bool X_ENDSTOPS_INVERTING = true" etc

I have not found X_ENDSTOPS_INVERTING in the current Marlin.pde file

Is this an addition , or out of date documentation ?

Any help appreciated in advance .


Author:  libelium-dev [ Mon Nov 18, 2013 8:53 am ]
Post subject:  Re: Setting up Marlin

Hello CEN,

Post in our community category.

If the community knows how to help you with your questions we will be glad to hear about it.


Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group