Cooking Hacks Forum
https://www.cooking-hacks.com/forum/

Setting up Marlin
https://www.cooking-hacks.com/forum/viewtopic.php?f=40&t=4263
Page 1 of 1

Author:  CEN [ Sun Nov 17, 2013 11:55 pm ]
Post subject:  Setting up Marlin

In the Marlin setup instructions there is a section that is highlighted
# define TEMP_SENSOR_0 1
# define TEMP_SENSOR_1 1
# define TEMP_SENSOR_2 1
# define TEMP_SENSOR_BED 1

Yet in the text

#define TEMP_SENSOR_0 7
#define TEMP_SENSOR_1 0
#define TEMP_SENSOR_2 0
#define TEMP_SENSOR_BED 1
and discusses "Depending of your Hot End, you will select one sensor or other."

I have http://www.cooking-hacks.com/shop/3d-pr ... e-extruder

Is this the correct setting for this nozzle/sensor ?

It also mentions "const bool X_ENDSTOPS_INVERTING = true" etc

I have not found X_ENDSTOPS_INVERTING in the current Marlin.pde file

Is this an addition , or out of date documentation ?

Any help appreciated in advance .

CEN

Author:  libelium-dev [ Mon Nov 18, 2013 8:53 am ]
Post subject:  Re: Setting up Marlin

Hello CEN,

Post in our community category.

If the community knows how to help you with your questions we will be glad to hear about it.

Regards.

Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/