|Cooking Hacks Forum
|Setting up Marlin
|Page 1 of 1|
|Author:||CEN [ Sun Nov 17, 2013 11:55 pm ]|
|Post subject:||Setting up Marlin|
In the Marlin setup instructions there is a section that is highlighted
# define TEMP_SENSOR_0 1
# define TEMP_SENSOR_1 1
# define TEMP_SENSOR_2 1
# define TEMP_SENSOR_BED 1
Yet in the text
#define TEMP_SENSOR_0 7
#define TEMP_SENSOR_1 0
#define TEMP_SENSOR_2 0
#define TEMP_SENSOR_BED 1
and discusses "Depending of your Hot End, you will select one sensor or other."
I have http://www.cooking-hacks.com/shop/3d-pr ... e-extruder
Is this the correct setting for this nozzle/sensor ?
It also mentions "const bool X_ENDSTOPS_INVERTING = true" etc
I have not found X_ENDSTOPS_INVERTING in the current Marlin.pde file
Is this an addition , or out of date documentation ?
Any help appreciated in advance .
|Author:||libelium-dev [ Mon Nov 18, 2013 8:53 am ]|
|Post subject:||Re: Setting up Marlin|
Post in our community category.
If the community knows how to help you with your questions we will be glad to hear about it.
|Page 1 of 1||All times are UTC + 1 hour|
|Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group