Cooking Hacks Forum
https://www.cooking-hacks.com/forum/

Patient Position Sensor
https://www.cooking-hacks.com/forum/viewtopic.php?f=39&t=5957
Page 1 of 1

Author:  Diana [ Tue Jul 08, 2014 9:10 am ]
Post subject:  Patient Position Sensor

Hi,

Ive just bought a patient position sensor and after using the arduino code given, the thing works out fine in the serial monitor. After awhile, using the same program, when the serial monitor came out, the message shows only (Current Position : Prone Position). But when i tilt to other position, the serial monitor didnt show any changes. btw, there is nothing wrong with the arduino board and the ehealth platform. and ive tried using other computer too but unfortunately, it didnt work. Is there anything i could do with the sensor?

Author:  libelium-dev [ Wed Jul 09, 2014 7:36 am ]
Post subject:  Re: Patient Position Sensor

Hello Diana,

Could you post some hardware connection photos?

Regards.

Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/