Post a new topicPost a reply Page 1 of 1   [ 2 posts ]
Author Message
 Post subject: Patient Position Sensor
PostPosted: Tue Jul 08, 2014 9:10 am 

Joined: Tue Jun 10, 2014 8:49 am
Posts: 4
Hi,

Ive just bought a patient position sensor and after using the arduino code given, the thing works out fine in the serial monitor. After awhile, using the same program, when the serial monitor came out, the message shows only (Current Position : Prone Position). But when i tilt to other position, the serial monitor didnt show any changes. btw, there is nothing wrong with the arduino board and the ehealth platform. and ive tried using other computer too but unfortunately, it didnt work. Is there anything i could do with the sensor?


Top
 Profile  
 
 Post subject: Re: Patient Position Sensor
PostPosted: Wed Jul 09, 2014 7:36 am 

Joined: Mon Sep 28, 2009 12:06 pm
Posts: 11311
Hello Diana,

Could you post some hardware connection photos?

Regards.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post a new topicPost a reply Page 1 of 1   [ 2 posts ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:


Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
Libelium theme based on 610nm Style by Daniel St. Jules of http://www.gamexe.net


© Libelium Comunicaciones Distribuidas S.L. | Terms of use.