| Cooking Hacks Forum https://www.cooking-hacks.com/forum/ |
|
| Patient position sensor (old version) pinout https://www.cooking-hacks.com/forum/viewtopic.php?f=39&t=18664 |
Page 1 of 1 |
| Author: | Christophe [ Fri Mar 22, 2019 12:17 pm ] |
| Post subject: | Patient position sensor (old version) pinout |
Bonjour I need to connect the Patient position sensor (the old one not the Pro version) directly to a standard Arduino and later to a Lolin D32 and I am looking for: 1. The cable pinout, I tried the schematic of the ehealth v2 but I didn't find it. 2. As the accelerometer (normaly a MMA8452Q) is working with 3.3 v for power and also for IC2 interface. Do I need to use resistor or a level shitter to protect IC2 interface or is already embedded in the belt circuit ? 3. Is IC2 pullout resistor need to be implemented or already embedded in the belt ? Regards |
|
| Author: | libelium-dev [ Tue Mar 26, 2019 12:54 pm ] |
| Post subject: | Re: Patient position sensor (old version) pinout |
Hi Christophe, You can find the schematics of the board in the next link, https://www.cooking-hacks.com/media/coo ... h_v2.0.pdf Hope this help. Regards. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|