Cooking Hacks Forum
https://www.cooking-hacks.com/forum/

MySignals SW output
https://www.cooking-hacks.com/forum/viewtopic.php?f=39&t=10797
Page 1 of 1

Author:  mlw [ Tue Oct 24, 2017 2:06 pm ]
Post subject:  MySignals SW output

Hello,

For an experiment I will need a system that monitors ECG data and initiates stimuli based on the ECG. As the equipment I use needs to be certified, I wondered whether it is possible to set up such a system using the MySignals Software. Is this possible to not only display the data, but also extract them and use them in a program for stimulus presentation?

Thanks for your help!

Author:  libelium-dev [ Wed Oct 25, 2017 7:46 am ]
Post subject:  Re: MySignals SW output

Hello mlw,

in this case, in which you are interested in extracting the information of ECG sensor to make your own application, we recommend MySignals HW.

https://www.cooking-hacks.com/mysignals-hw-ehealth-medical-biometric-iot-platform-arduino-tutorial/

You have a code available to read the raw data of the ECG wave:

Code:
/*

    Copyright (C) 2016 Libelium Comunicaciones Distribuidas S.L.
   http://www.libelium.com

    By using it you accept the MySignals Terms and Conditions.
    You can find them at: http://libelium.com/legal

    This program is free software: you can redistribute it and/or modify
    it under the terms of the GNU General Public License as published by
    the Free Software Foundation, either version 3 of the License, or
    (at your option) any later version.

    This program is distributed in the hope that it will be useful,
    but WITHOUT ANY WARRANTY; without even the implied warranty of
    MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
    GNU General Public License for more details.

    You should have received a copy of the GNU General Public License
    along with this program.  If not, see <http://www.gnu.org/licenses/>.

    Version:           0.1
    Design:            David Gascon
    Implementation:    Luis Martin / Victor Boria
*/

#include <MySignals.h>
#include "Wire.h"
#include "SPI.h"


void setup()
{
  Serial.begin(115200);
  MySignals.begin();
}



void loop()
{

  float ECG = MySignals.getECG(VOLTAGE);

  Serial.print("ECG value :  ");
  Serial.print(ECG, 2);
  Serial.println(" V"); 
 
  // wait for a millisecond
  delay(1);   
 
}


Regards

Author:  mlw [ Tue Oct 31, 2017 1:11 pm ]
Post subject:  Re: MySignals SW output

Hello,

Thanks for your reply! I have considered this option indeed, but I can only used certified equipment. The MySignals HW is not certified at the moment right? Will this change in the near future?

Best,
Marieke

Author:  libelium-dev [ Thu Nov 02, 2017 8:34 am ]
Post subject:  Re: MySignals SW output

Hello mlw,

we have no plans to certify this boards.

Regards

Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/