Hello everyone,
I´ve got a question. Is it normal that the serial monitor displays the data just once, doesn´t update any changes and proceeds to show it like this:
https://www.dropbox.com/s/902dqqyw73mea ... 8.png?dl=0
I´m kinda baffled, because this isn´t metioned anywhere and I can´t make out what´s wrong, if there is anything wrong, heck I seriously don´t know anymore.

I already tried serveral Arduino Unos, and two e-Health Shields, I´m using arduino IDE 1.0.6 and the latest library 2.4. I also used the Pulsoximeter example code from the library.
My setup looks like this:
https://www.dropbox.com/s/46w2scbzy9ahs ... 4.jpg?dl=0

I just want to know if this is normal, or if possibly my boards or something else is broken, because I nowhere I found an example of this.

Kind regards,
Dave

Hi Dave626,

Can you tell us your order number?


In this photo we can see that you have got the baud rate in the serial monitor at 9600 and in the sketch is at 115200. Something is wrong and maybe it is your problem.

Can you check it?

Thanks.

Regards

Heyho,

Yes that helped, I´m sorry for that mess up on my part.
Now the only Problem I have left is that my ECG is not really working it just shows values between 0.05 and 0.08 V. But I´m searching the forum for a solution.
Could you tell me in which order the Electrodes are meant to be put in? I can´t seem to figure out which one is the +, - and neutral connection on the board.

Hi Dave626,


Be sure that you put the EMG/ECG jumper in the correct position:





You can see it in the bottom of the board:



Regards