Cooking Hacks Forum
https://www.cooking-hacks.com/forum/

ECG data problem
https://www.cooking-hacks.com/forum/viewtopic.php?f=39&t=10702
Page 1 of 1

Author:  hhhddd [ Sun Oct 01, 2017 9:21 am ]
Post subject:  ECG data problem

Hi everyone

I'm reading ECG values via serial connection.
But the values returned do not change either the electrodes are attached to the body surface or not.
What's happening?

best regards

Author:  libelium-dev [ Mon Oct 02, 2017 8:17 am ]
Post subject:  Re: ECG data problem

Hello hhhddd,

have you put the jumper in eHealth board in ECG position?

Regards.

Author:  hhhddd [ Mon Oct 02, 2017 2:30 pm ]
Post subject:  Re: ECG data problem

Yes, I put the jumper on the board.

I tried two positions (for ECG and EMG measurement), but in both cases, I didn't get satisfactory results.

Is there anything else that I should check?

Best

Author:  libelium-dev [ Tue Oct 03, 2017 8:13 am ]
Post subject:  Re: ECG data problem

Hello hhhddd,

could you post some photos of your hardware connection? Are you using Arduino Uno?

Regards

Author:  hhhddd [ Wed Oct 04, 2017 5:10 pm ]
Post subject:  Re: ECG data problem

HI,

I don't know why, but now the brard is picking up signals.

Is it just a problem of e-health sensors instability?

best regards

Author:  libelium-dev [ Thu Oct 05, 2017 8:21 am ]
Post subject:  Re: ECG data problem

Hello hhhddd,

We are glad that it already works, thanks for your contribution.

Regards

Author:  hhhddd [ Thu Oct 12, 2017 5:06 am ]
Post subject:  Re: ECG data problem

Thank you.
But what about the instability problem?

Author:  libelium-dev [ Mon Oct 16, 2017 8:46 am ]
Post subject:  Re: ECG data problem

Hello hhhddd,

we have already answered you here:
viewtopic.php?f=39&t=10719&p=33423&sid=e003995d810c755d04f1a473055b4071#p33423

Regards

Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/