Cooking Hacks Forum

e-Health wi-fi module
Page 2 of 2

Author:  Seiya [ Mon May 14, 2018 10:03 pm ]
Post subject:  Re: e-Health wi-fi module ... GE5Su/view

I think that the device I am using at the URL above is displayed.

I am using ArduinoUNO but can I try it with another version of Arduino?
Let's try using another Arduino UNO for the time being.

I think that the correct board and port can be selected.
When disconnecting Arduino, the board is displayed as if it can not be recognized, and when using another sample code it was able to run without problems.

Author:  libelium-dev [ Tue May 15, 2018 9:42 am ]
Post subject:  Re: e-Health wi-fi module


The Xbee shield uses UART and UART is also used to upload the program to Arduino, so it cases conflicts. Please try to put the switch of the XBee shield to the another position.


Author:  Seiya [ Wed May 23, 2018 10:32 am ]
Post subject:  Re: e-Health wi-fi module

Thank you! That error was resolved.
However, even if you enter the sample code, nothing will happen just by printing the letters.

Execution result ... UHww5ALniF

Does this result say that the sample code is working?

Author:  libelium-dev [ Thu May 24, 2018 9:06 am ]
Post subject:  Re: e-Health wi-fi module


It seems the correct output. They are the commands sent to the module.


Page 2 of 2 All times are UTC + 1 hour
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group