Hi,

I have and two Arduino + shield + LoRa(SX1272) and I have bought three sensors in cooking hacks. The sensors are:
https://www.cooking-hacks.com/conductivity-sensor
https://www.cooking-hacks.com/dissolved-oxygen-sensor
https://www.cooking-hacks.com/ultrasound-outdoor-ip67

I've been looking the libelium documentation and I've seen that in all tutorials is used the WaspSensorSW.h library of Waspmote.
Can I do it with my Arduino + shield + LoRa(SX1272) pack ?
If so, is there any tutorial ? Can I do it with the same library?

Thanks in advance.

Hi escalass,


This sensor is compatible with Arduino if you use our Open-Garden or Open Aquarium board with the Aquaponics/Hydroponics shield. These board include the adaptation circuit of the sensor.


This sensor is only compatible with Waspmote and the Smart Water sensor board. Not with Arduino.


This sensor is compatible with Waspmote v15, we have never integrated it in Arduino.


No, we haven't got a tutorial for these sensors for Arduino, also they are not directly compatible because you need the adaptation circuit of each sensor. You will need to use the recommended board for each sensor if you want to use them.

Regards

Hi thanks for your answer,

I want to try it first with Arduinos doing an adaptation circuit, but I need the three datasheets of the sensors and I haven't seen it on you website. I have found the dissolved oxygen sensor datasheet but I'm not able to find the other two.


Could you please provide the links to the datasheet?

Thanks in advance.

Hi escalass,

All the information available about these sensor is in the webpage and in the Libelium's technical guides:

http://www.libelium.com/development/was ... mentation/

We haven't got the datasheets to download.

Regards

Hi again,

I have the conductivity calibration kit probe and I have a doubt. In the pots the units are microSiemens and wanted to know if its is microSiemens/cm.

Thanks in Advance.

Hi escalass,

The units of the conductivity calibration kit probe are microSiemens.

Regards