My Cart

Dot/Bar Display Driver - LM3914 (Linear)

1.95 €1.95

Availability: Retired

This is the LM3914 Dot/Bar display analog-controlled LED driver that uses an alinear output scale. With this driver all it takes is a single, analog signal to drive a string of 10+ LEDs, which can be configured into either bar mode (where all LEDs below a certain point turn on) or dot mode (with only a single LED on at a time). Hook them up properly, and you can create all sorts of nifty multi-LED displays. The LM3914 is very easy to apply as an analog meter circuit. A 1.2V full-scale meter requires only 1 resistor and a single 3V to 15V supply in addition to the 10 display LEDs. If the 1 resistor is a pot, it becomes the LED brightness control. The simplified block diagram illustrates this extremely simple external circuitry.Features:Drives LEDs, LCDs or Vacuum FluorescentsBar or Dot Display Mode Externally SelectableExpandable to Displays of 100 StepsInternal Voltage Reference from 1.2V to 12VOperates with Single Supply of Less than 3VOutputs can Interface with TTL or CMOS LogicDocuments:DatasheetHookup GuideProduct Video

Description

This is the LM3914 Dot/Bar display analog-controlled LED driver that uses an alinear output scale. With this driver all it takes is a single, analog signal to drive a string of 10+ LEDs, which can be configured into either bar mode (where all LEDs below a certain point turn on) or dot mode (with only a single LED on at a time). Hook them up properly, and you can create all sorts of nifty multi-LED displays. The LM3914 is very easy to apply as an analog meter circuit. A 1.2V full-scale meter requires only 1 resistor and a single 3V to 15V supply in addition to the 10 display LEDs. If the 1 resistor is a pot, it becomes the LED brightness control. The simplified block diagram illustrates this extremely simple external circuitry.Features:Drives LEDs, LCDs or Vacuum FluorescentsBar or Dot Display Mode Externally SelectableExpandable to Displays of 100 StepsInternal Voltage Reference from 1.2V to 12VOperates with Single Supply of Less than 3VOutputs can Interface with TTL or CMOS LogicDocuments:DatasheetHookup GuideProduct Video

If you are interested in Internet of Things (IoT) or M2M projects check our open source sensor platform Waspmote which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.

Know more at:

Get the Starter Kits at: