My Cart

CUhead Pro

24.95 €24.95

Availability: Retired

This is the CUhead Pro, a WiFi/Ethernet Arduino shield with Airplay and DLNA audio and also acts as an access point for WiFi devices. It also makes julienne fries! Alright, that last one may have been a stretch but with this shield you WILL be able to wirelessly push music and other sounds from your iOS and Android device and more. With very minimal work and programming you can have this versatile little guy up and running in no time. As the CUhead Pro is a shield, simply plug it into your Arduino based dev board and start transmitting. The CUhead Pro is equipped with USB-A port, RJ45 ethernet port (just in case there isn’t a WiFi signal), and a 3.5mm audio jack. It is important to note that on this shield the USB host is reversed for future firmware updates. An interesting feature about the CUhead Pro is the detachable WiFi module with an RT5350 SoC chip from Ralink. The RT5350 SoC combines Ralink’s IEEE 802.11n draft compliant 1T1R MAC/BBP/PA/RF, a high performance 360 MHz MIPS24KEc CPU core, a 5-port integrated 10/100 Ethernet switch/PHY and a USB host/device.Note: LinkSprite has completed working on OpenWRT support! Check the link in the Documents section below for more information.Documents:Datasheet (RT5350)CUhead Pro Wiki (Warning: Lady Gaga)Port OpenWRT to CUhead ProProduct Video

Description

This is the CUhead Pro, a WiFi/Ethernet Arduino shield with Airplay and DLNA audio and also acts as an access point for WiFi devices. It also makes julienne fries! Alright, that last one may have been a stretch but with this shield you WILL be able to wirelessly push music and other sounds from your iOS and Android device and more. With very minimal work and programming you can have this versatile little guy up and running in no time. As the CUhead Pro is a shield, simply plug it into your Arduino based dev board and start transmitting. The CUhead Pro is equipped with USB-A port, RJ45 ethernet port (just in case there isn’t a WiFi signal), and a 3.5mm audio jack. It is important to note that on this shield the USB host is reversed for future firmware updates. An interesting feature about the CUhead Pro is the detachable WiFi module with an RT5350 SoC chip from Ralink. The RT5350 SoC combines Ralink’s IEEE 802.11n draft compliant 1T1R MAC/BBP/PA/RF, a high performance 360 MHz MIPS24KEc CPU core, a 5-port integrated 10/100 Ethernet switch/PHY and a USB host/device.Note: LinkSprite has completed working on OpenWRT support! Check the link in the Documents section below for more information.Documents:Datasheet (RT5350)CUhead Pro Wiki (Warning: Lady Gaga)Port OpenWRT to CUhead ProProduct Video

If you are interested in Internet of Things (IoT) or M2M projects check our open source sensor platform Waspmote which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.

Know more at:

Get the Starter Kits at: