My Cart

Bluetooth Bee - Standalone

22 €22.00

Availability: Retired

Save that extra Arduino you have lying around for another project, this two-for-one device has the Arduino built-in. Bluetooth Bee with Arduino is an enhanced version of the Bluetooth Bee. We added an onboard ATMEGA168 to it to make it a full-featured Arduino while maintaining the same footprint and instruction set as the Bluetooth Bee.

Description

Save that extra Arduino you have lying around for another project, this two-for-one device has the Arduino built-in. Bluetooth Bee with Arduino is an enhanced version of the Bluetooth Bee. We added an onboard ATMEGA168 to it to make it a full-featured Arduino while maintaining the same footprint and instruction set as the Bluetooth Bee. Plus, it still allows you to stack it on XBee Carrier, XBee Shield, and UartSBee for expansion or reprogramming

Hardware Features
  • Typical -80dBm sensitivity
  • +4dBm RF transmit power
  • Fully qualified Bluetooth V2.0+EDR 3Mbps Modulation
  • Operating voltage: 3.3v
  • Built-in antenna
Software Features
  • Software serial port communication method
  • Default Baud rate: 38400
  • Supported Baud rate: 9600, 19200, 38400, 57600, 115200, 230400, 460800
  • Under RTS/CTS data transmit-receive framework
  • Auto connect the last device on power as default
  • Auto-reconnect in 30 minutes after out-of-range disconnection
  • Ability to disconnect via a rising edge on PC2
  • Working status signal on PB2: low not working, high working
  • Paired-up status indicator on PIO 10(a red LED) and PIO 11(a blue LED):
    • Paired: red and blue blinks 1 time/2s in interval
    • Unpaired: blue blinks 2 times/sec
  • Default pincode: 0000
Application Ideas
  • Bluetooth communication for Arduino projects
  • Turn your computer into a Bluetooth device with UartSBees USB interface

If you are interested in Internet of Things (IoT) or M2M projects check our open source sensor platform Waspmote which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.

Know more at:

Get the Starter Kits at: