My Cart

BBAC - Breadboard Based Arduino Compatible

16.9 €16.90

Availability: Retired

This is a kit with all the components you need to produce your very own Arduino compatible on a breadboard. Simply place the included layout sheet on the breadboard then follow the fun Lego style assembly instructions in the included printed manual.   NOTE: This kit does not include any USB circuitry, thus to program it you will either require a spare Arduino USB (duemilanove or uno) board, or an FTDI USB-Serial programming cable (available here). (Instructions included)   Features Easy to assemble with printed guide and breadboard layout sheet. Fully compatible with the Arduino IDE.   Includes Printed Color Assembly Guide Printed Color Breadboard Layout Sheet (to make component placement easy) 400 Contact Breadboard ATMega328 (with Arduino bootloader preloaded (Duemilanove)) 16 MHz Crystal Capacitors (2x100uf, 2x100nf, 2x22pf) Resistors (2x560ohm, 2x10k ohm, 12x 0 ohm) LEDs (Red power, green pin 13) Jumper Wires Pushbutton (for reset) 6 Pin Header (for programming with an FTDI USB-Serial cable) 7805 Voltage Regulator 9v battery clip  

Description

This is a kit with all the components you need to produce your very own Arduino compatible on a breadboard. Simply place the included layout sheet on the breadboard then follow the fun Lego style assembly instructions in the included printed manual.   NOTE: This kit does not include any USB circuitry, thus to program it you will either require a spare Arduino USB (duemilanove or uno) board, or an FTDI USB-Serial programming cable (available here). (Instructions included)   Features Easy to assemble with printed guide and breadboard layout sheet. Fully compatible with the Arduino IDE.   Includes Printed Color Assembly Guide Printed Color Breadboard Layout Sheet (to make component placement easy) 400 Contact Breadboard ATMega328 (with Arduino bootloader preloaded (Duemilanove)) 16 MHz Crystal Capacitors (2x100uf, 2x100nf, 2x22pf) Resistors (2x560ohm, 2x10k ohm, 12x 0 ohm) LEDs (Red power, green pin 13) Jumper Wires Pushbutton (for reset) 6 Pin Header (for programming with an FTDI USB-Serial cable) 7805 Voltage Regulator 9v battery clip  

If you are interested in Internet of Things (IoT) or M2M projects check our open source sensor platform Waspmote which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.

Know more at:

Get the Starter Kits at: