My Cart

Arch Link

39.95 €39.95

Availability: Retired

Arch Link is an mbed enabled development board based on Nordic nRF51822 and WIZnet W5500 ethernet interface. With Arduino form factor, Grove connectors and micro SD interface, it is extremely easy to create a bluetooth low energy device.    Features:   mbed enabled Online IDE Easy to use C/C++ SDK Handy libraries CMSIS DAP based on LPC11U35 Drag-n-drop programming Debug using CMSIS DAP standard USB virtual serial for communication Arduino form factor with Grove connectors I2C and UART connecter on board Nordic nRF51822 Multi-protocol Bluetooth® 4.0 low energy/2.4GHz RF SoC ARM Cortex M0 processor 256kB flash/16kB RAM Configurable I/O mapping for digital I/O WIZnet W5500 Ethernet Supports following Hardwired TCP/IP Protocols : TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE Supports Power down mode Supports Wake on LAN over UDP Supports High Speed Serial Peripheral Interface(SPI MODE 0, 3) Internal 32Kbytes Memory for Tx/Rx Buffers 10BaseT/100BaseTX Ethernet PHY embedded with RJ45 connector USB Micro B connector   Micro SD Card connector     Please visit our wiki page for more info about this product. You can share your awesome projects to recipe, where you can find what the other makers will make with this shield as well. For technical support, please post your questions to our forum.

Description

Arch Link is an mbed enabled development board based on Nordic nRF51822 and WIZnet W5500 ethernet interface. With Arduino form factor, Grove connectors and micro SD interface, it is extremely easy to create a bluetooth low energy device.    Features:   mbed enabled Online IDE Easy to use C/C++ SDK Handy libraries CMSIS DAP based on LPC11U35 Drag-n-drop programming Debug using CMSIS DAP standard USB virtual serial for communication Arduino form factor with Grove connectors I2C and UART connecter on board Nordic nRF51822 Multi-protocol Bluetooth® 4.0 low energy/2.4GHz RF SoC ARM Cortex M0 processor 256kB flash/16kB RAM Configurable I/O mapping for digital I/O WIZnet W5500 Ethernet Supports following Hardwired TCP/IP Protocols : TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE Supports Power down mode Supports Wake on LAN over UDP Supports High Speed Serial Peripheral Interface(SPI MODE 0, 3) Internal 32Kbytes Memory for Tx/Rx Buffers 10BaseT/100BaseTX Ethernet PHY embedded with RJ45 connector USB Micro B connector   Micro SD Card connector     Please visit our wiki page for more info about this product. You can share your awesome projects to recipe, where you can find what the other makers will make with this shield as well. For technical support, please post your questions to our forum.

If you are interested in Internet of Things (IoT) or M2M projects check our open source sensor platform Waspmote which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.

Know more at:

Get the Starter Kits at: