The PowerTap is tiny (less than 1â€ť square) accessory board for simplifying the hookup of power on long runs of LEDs. Due to voltage drops over long strips, it is recommended to inject power every 5m or 5A, whichever comes first. With the PowerTap, you can build in a quick connect/disconnect power port in between your sections of LEDs. Very basic soldering skills required to assemble the board. Â Features:Â 2.1mm DC barrel jack for input of 5-12V @ up to 5A Input and output 0.1â€ť spacing screw terminals. Data, Clock, and Ground are carried along to the other side while power is only sent to the output terminal to the next section of LEDs 1000uF capacitor for smoothing out power fluctuations Â Part List: PowerTap board 2.1mm DC barrel jack 2x 0.1â€ť screw terminal 1000uF Capacitor Â ManiacalÂ Labs SupportÂ Forum AllPixelÂ QuickStartÂ Guide Â If you have any questions, feel free to send us an Â emailÂ Â to service. Â For any technical support or suggestion, please kindly go to our?forum.
If you are interested in Internet of Things (IoT) or M2M projects check our open
source sensor platform Waspmote
which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.
Know more at:
Get the Starter Kits at: