A Difficult Choice Made Easy
The choice of LiPo batteries and battery chargers can be overwhelming. In the past, with older RC cars and NiCd batteries, you could just take the battery, plug it into a wall charger, and leave it. After several hours, or preferably overnight, your battery would be ready for use again. LiPo batteries are a completely different animal.
If you donâ€™t select a higher-end charging station, they will require a lot of your time and attention. And if you donâ€™t treat them right, they can be downright dangerous.
But with this 7.4V Lipo Battery Charger, things become just as easy as before. This charge is able to take inÂ AC100-240V 50/60HzÂ power and output atÂ DC 8.5V 1.5A. It comes with standardÂ DC 2.1mm (Female/Male)Â interface which is Arduino compatible, and hasÂ short-circuit protection, reverse-connection protection, over-charge protection and backflow protection protection. A perfect companion to theÂ 7.4V Lipo Battery (2-cell pack).
Input: AC100-240V 50/60Hz Output: DC 8.5V 1.5A Interface: DC 2.1mm (Female/Male) (Arduino compatible) Led Indicator: Red (charging), Green (charged), Green Flash (protection mode triggered) Support Battery: 7.4V Lipo Battery (2-cell pack) Protection: converse connection, over-charge and discharge over-loading, short-circuit protection. Certification: CE,UL,FCC,GS Size: 70 mm Ă— 75 mm Ă— 40 mm Weight: Â 90g
7.4V Lipo Battery charger x1 DC 2.1mm female to female connector x1
If you are interested in Internet of Things (IoT) or M2M projects check our open
source sensor platform Waspmote
which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.
Know more at:
Get the Starter Kits at: