My Cart

24.5mm Coin Cell Breakout

2.4 €2.40

Availability: Retired

This is a simple breakout board for our through-hole 24.5 mm coin cell holder. All you need to do is solder the tabs of the holder down and you're good to go! There are also two mounting holes for attaching it to your project.

Note: We've found that applying a bit of solder to the large solder pad in the middle creates a better connection with the negative side of the battery.

Note: You will get just the bare PCB. Check below for the coin cell holder that you will need to solder to the board.

Documents:

Description

This is a simple breakout board for our through-hole 24.5 mm coin cell holder. All you need to do is solder the tabs of the holder down and you're good to go! There are also two mounting holes for attaching it to your project.

Note: We've found that applying a bit of solder to the large solder pad in the middle creates a better connection with the negative side of the battery.

Note: You will get just the bare PCB. Check below for the coin cell holder that you will need to solder to the board.

Documents:

If you are interested in Internet of Things (IoT) or M2M projects check our open source sensor platform Waspmote which counts with more than 100 sensors available to use 'off the shelf', a complete API with hundreds of ready to use codes and a low consumption mode of just 0.7µA to ensure years of battery life.

Know more at:

Get the Starter Kits at: