Enclosures

The Arduino enclosure allows you to easily enclose your Arduino main board, Arduino Mega, or some of the other board that fits the Arduino foot print. It simply presses shut, so you don't have to worry about screws or fasteners.

It has room internally for an Arduino and a shield. It even has a removable tab mated for use with an Ethernet shield. It also has a snap-in compartment in the back for accessing switches or connections or battery access.

Note: Some older Arduino boards have a slightly smaller hole near the rear the ICSP connector. To make the case work with these boards simply drill out the hole to 1/8" and you will be fine. Also, with the newer Ethernet Shields, you will need to remove one of the pegs to get everything to fit correctly.

Note: This does not work with the FEZ Domino.

Dimensions: 87x64x28mm

This is a very simple, but surprisingly handy project box designed by SparkFun. The box comes with three plastic pieces and includes 4 screws. The insert on the end of the box can be CNC milled (or just dremeled out by hand) for connectors, LEDs, switches.

The bottom section of the enclosure has a unique pattern of raised dots. These dots are on a 0.2" grid. Our plastic standoffs fit nicely onto the 0.09" diameter dots. This allows for a large number of standoff configurations. Using our plastic standoffs, you can mount any shaped board into the enclosure. A small amount of super glue or hot glue will make the mounting permanent.

The outer corners of the SFE box also fit a Eurocard sized PCB (100x80mm). This makes the SFE box ideal for enclosing Olimex and other large development boards.

Documents:

• Dimensional Drawing
• PCB Size Format (pdf) (dxf)

The box comes with three plastic pieces and includes 4 screws. The insert on the end of the box can be CNC milled (or just dremeled out by hand) for connectors, LEDs, switches.

The bottom section of the enclosure has a unique pattern of raised dots. These dots are on a 0.2" grid. Our plastic standoffs fit nicely onto the 0.09" diameter dots. This allows for a large number of standoff configurations. Using our plastic standoffs, you can mount any shaped board into the enclosure. A small amount of super glue or hot glue will make the mounting permanent.

The outer corners of the SFE box also fit a Eurocard sized PCB (100x80mm). This makes the SFE box ideal for enclosing Olimex and other large development boards.

Documents:

• Dimensional Drawing
• PCB Size Format (pdf) (dxf)

Out dimension: 111*67*16 (mm)
Inner dimension: 110*60*12 (mm)
Waterproof: No

Aluminum with oxidized surface, Silver steel color.

Out dimension: 113*70*25 (mm)
Inner dimension: 110*65*21 (mm)
Waterproof: No
Double trail for 1.6mm thick boards.

Aluminum with oxidized surface, gray steel color.