Relay Module (Arduino Compatible)

The DFRobot Single Relay blocks the number of electronic modules. It can be used in interactive projects.  It can also be used to control the lighting, electrical and other equipments. The modular design makes it easy to expand with the Arduino board (not included). The Relay output state by a light-emitting diode. It can be controlled through the digital IO port, such as solenoid valves, lamps, motors and other high current or high voltage devices. It includes the digital cable.

Specification

• Type: Digital


• Single relay board


• Rated through-current: 10A (NO) 5A (NC)


• Maximum switching voltage: 150VAC 24VDC


• Digital interface


• Control signal: TTL level


• Rated load: 8A 150VAC (NO) 10A 24VDC (NO), 5A 250VAC (NO/NC) 5A 24VDC (NO/NC)


• Rated through-current: 10A (NO) 5A (NC)


• Maximum switching voltage: 150VAC 24VDC


• Maximum switching power: AC1200VA DC240W (NO) AC625VA DC120W (NC)


• Contact action time: 10ms following


• Module pin definitions: One foot - control side, two feet - Power supply (VCC), 3 feet - ground

Documents

• Wiki Doc


• Datasheet


• How to use relay tutorial