Waspmote

The Waspmote Agriculture Board allows to monitor multiple environmental parameters involving a wide range of applications, from growing development analysis to weather observation. For this, it has been provided with sensors for air and soil temperature and humidity, solar visible radiation, wind speed and direction, rainfall, atmospheric pressure, leaf wetness and fruit or trunk diameter (dendrometer). Up to 14 sensors can be connected at the same time. With the objective of extending the durability of the device after the deployment, the board is endowed with a solid state switches system that facilitates a precise regulation of its power, prolonging the life if the battery.

The Waspmote Agriculture Board may take up to 14 sensors. This kit includes 3 of them for testing purposes.

This kit includes:
x1 Waspmote Agriculture Sensor Board
x1 Digital Temperature & Humidity Sensor
x1 Soil Moisture Sensor
x1 Atmospheric Pressure Sensor

Documentation:
Waspmote Agriculture Board Guide
Waspmote Quick Tutorial
Waspmote Site 
Waspmote Technical Guides 
Sensor Boards Technical Guides 
Networking Guides 
Developers Forum 
Videos 
Articles 
50 Applications with Waspmote 
FAQ: Waspmote Vs. Arduino

The sensors are active on the Events Board while Waspmote is in Sleep or Deep Sleep mode. When a sensor picks up a value higher than a previously programmed threshold, a signal is generated which wakes the mote from its low consumption status and tells it which sensor has generated the signal.

The Events Sensor Board may take up to 8 sensors. This kit includes 4 of them.

This kit includes:
x1 Waspmote Events Sensor Board
x1 Temperature Sensor
x1 Light Sensor
x1 PIR Sensor
x1 Liquid Presence Sensor

Documentation:
Waspmote Events Board Guide
Waspmote Quick Tutorial
Waspmote Site 
Waspmote Technical Guides 
Sensor Boards Technical Guides 
Networking Guides 
Developers Forum 
Videos 
Articles 
50 Applications with Waspmote 
FAQ: Waspmote Vs. Arduino

The Waspmote Gases 2.0 board has been designed to monitor environmental parameters such as temperature, humidity, atmospheric pressure and 14 different types of gases. It allows the inclusion of 6 gases sensors at the same time, the regulation of their power through a system of solid state switches and the amplification of the output signal of each one of them through a non-inverting amplification stage of a maximum gain of 101 controlled by a digital potentiometer configurable through the Inter-Integrated Circuit Bus, I2C).

The Waspmote Gases Board may take up to 14 gas sensors. This kit includes 4 of them.

This kit includes:
x1 Waspmote Gases Board
x1 Temperature Sensor
x1 Humidity Sensor
x1 CO Sensor
x1 CO2 Sensor

Documentation:
Waspmote Gases Board Guide
Waspmote Quick Tutorial
Waspmote Site 
Waspmote Technical Guides 
Sensor Boards Technical Guides 
Networking Guides 
Developers Forum 
Videos 
Articles 
50 Applications with Waspmote 
FAQ: Waspmote Vs. Arduino

Waspmote is an open source wireless sensor platformspecially focused on the implementation of low consumption modes which allows the sensor nodes ("motes") to be completely autonomous, that is battery powered. Lifetime of Waspmote sensor nodes may go from 1 to 5 years depending on the duty cycle and the radio used.

Waspmote is based on a modular architecture. The idea is tointegrate only the modules needed in each device optimizing costs. For this reason all the modules (radios, sensor boards, etc) plug in Waspmote through sockets.

This kit includes:
x1 Waspmote Expansion Board
x1 GSM/GPRS Waspmote Module (GSM antenna included)
x1 GPS Waspmote Module (GPS antenna included)
x1 Waspmote Wifi Module 2 dBi
x1 Waspmote Bluetooth PRO Module 5 dBi

Documentation:
Waspmote Quick Tutorial
Waspmote Site 
Waspmote Technical Guides 
Sensor Boards Technical Guides 
Networking Guides 
Developers Forum 
Videos 
Articles 
50 Applications with Waspmote 
FAQ: Waspmote Vs. Arduino

Featured in:  

NOTE: Orders from 26th February comes with the new version of Waspmote

Waspmote is an open source wireless sensor platform specially focused on the implementation of low consumption modes which allows the sensor nodes ("motes") to be completely autonomous, that is battery powered. Lifetime of Waspmote sensor nodes may go from 1 to 5 years depending on the duty cycle and the radio used.

Waspmote is based on a modular architecture. The idea is to integrate only the modules needed in each device optimizing costs. For this reason all the modules (radios, sensor boards, etc) plug in Waspmote through sockets.

This kit includes:
x1 Waspmote 802.15.4 SMA 2dBi
x1 Waspmote Gateway 802.15.4 SMA 2dBi
x1 2300 mAh LiPo Battery
x1 miniUSB Cable

The modules available for integration in Waspmote are categorised in:
- ZigBee:/802.15.4 modules (2.4GHz, 868MHz, 900MHz). Low and high power.
- GSM - 3G/GPRS Module (Quadband: 850MHz/900MHz/1800MHz/1900MHz)
- Sensor Modules (Sensor boards)
- Storage Module: SD Memory Card
- GPS Module

Documentation:
Waspmote Quick Tutorial
Waspmote Site 
Waspmote Technical Guides 
Sensor Boards Technical Guides 
Networking Guides 
Developers Forum 
Videos 
Articles 
50 Applications with Waspmote 
FAQ: Waspmote Vs. Arduino

Waspmote is an open source wireless sensor platform specially focused on the implementation of low consumption modes which allows the sensor nodes ("motes") to be completely autonomous, that is battery powered. Lifetime of Waspmote sensor nodes may go from 1 to 5 years depending on the duty cycle and the radio used.

Waspmote is based on a modular architecture. The idea is to integrate only the modules needed in each device optimizing costs. For this reason all the modules (radios, sensor boards, etc) plug in Waspmote through sockets.

This kit includes:
x5 Waspmote 802.15.4 PRO SMA 2 DBI
x1 Waspmote Gateway 802.15.4 PRO SMA 2 DBI
x1 Gases Board
x1 Events Board
x1 Temperature Sensor
x1 Humidity Sensor
x1 GPS Module
x1 GSM / GPRS Module
x2 2300 mA/h rechargeable battery
x2 6600 mA/h rechargeable battery
x1 13 A/h non-rechargeable battery

Documentation:
Waspmote Quick Tutorial
Waspmote Site 
Waspmote Technical Guides 
Sensor Boards Technical Guides 
Networking Guides 
Developers Forum 
Videos 
Articles 
50 Applications with Waspmote 
FAQ: Waspmote Vs. Arduino

Waspmote is an open source wireless sensor platform specially focused on the implementation of low consumption modes which allows the sensor nodes ("motes") to be completely autonomous, that is battery powered. Lifetime of Waspmote sensor nodes may go from 1 to 5 years depending on the duty cycle and the radio used.

Waspmote is based on a modular architecture. The idea is to integrate only the modules needed in each device optimizing costs. For this reason all the modules (radios, sensor boards, etc) plug in Waspmote through sockets.

This kit includes:
x5 Waspmote ZB PRO SMA 2 DBI
x1 Waspmote Gateway ZB PRO SMA 2 DBI
x1 Gases Board
x1 Events Board
x1 Temperature Sensor
x1 Humidity Sensor
x1 GPS Module
x1 GSM / GPRS Module
x2 2300 mA/h rechargeable battery
x2 6600 mA/h rechargeable battery
x1 13 A/h non-rechargeable battery

Documentation:
Waspmote Quick Tutorial
Waspmote Site 
Waspmote Technical Guides 
Sensor Boards Technical Guides 
Networking Guides 
Developers Forum 
Videos 
Articles 
50 Applications with Waspmote 
FAQ: Waspmote Vs. Arduino

Waspmote is an open source wireless sensor platform specially focused on the implementation of low consumption modes which allows the sensor nodes ("motes") to be completely autonomous, that is battery powered. Lifetime of Waspmote sensor nodes may go from 1 to 5 years depending on the duty cycle and the radio used.

Waspmote is based on a modular architecture. The idea is to integrate only the modules needed in each device optimizing costs. For this reason all the modules (radios, sensor boards, etc) plug in Waspmote through sockets.

Previously configured equipment for demonstrations, this kit allows to get a wide range of applications to learn how to use Waspmote.

The Code and the Demo app can be downloaded from here. Available for Linux, Windows and Mac-OS

This kit includes:
x2 Waspmote 802.15.4 SMA 2 DBI
x3 Waspmote 802.15.4 PRO SMA 2 DBI
x1 Waspmote Gateway 802.15.4 SMA 2
x1 Gases Board
x1 Events Board
x1 Prototyping Board
x1 Temperature Sensor
x1 Humidity Sensor
x1 Atmospheric pressure
x1 CO Sensor
x1 O2 Sensor
x1 Luminosity Sensor
x1 Presence Sensor (PIR)
x1 Pressure/ Weight Sensor
x1 Water pressence Sensor
x1 Hall effect Sensor
x1 Bend Sensor
x1 Relay 10A Sensor
x1 GPS Module
x1 GSM / GPRS Module
x2 2300 mA/h rechargeable battery
x2 6600 mA/h rechargeable battery
x1 13 A/h non-rechargeable battery

Documentation:
Waspmote Quick Tutorial
Waspmote Site 
Waspmote Technical Guides 
Sensor Boards Technical Guides 
Networking Guides 
Developers Forum 
Videos 
Articles 
50 Applications with Waspmote 
FAQ: Waspmote Vs. Arduino