libelium
  • rss
  • flickr
  • twitter
  • facebook
  • youtube

Battery Holder - 4xAA to Barrel Jack Connector

Be the first to review this product

€2.55

Availability: Back Order More info

Quick Overview

This is a simple 4 cell AA battery holder. The 5 inch cable is terminated with a standard 5.5x2.1mm, center positive barrel jack connector.


The connector mates with the barrel jack on the Arduino (among a number of other products) allowing you to easily make your project battery powered.


Note: the average voltage regulator has about 1V of dropout (but can vary greatly). This pack, with normal alkaline batteries, will output ~5.5V causing a normal 5V board to run at around 4 to 4.5V. This depends a lot of what board and processor you are using with the battery pack. Please consult yer datasheet.

Battery Holder - 4xAA to Barrel Jack Connector

Double click on above image to view full picture

Zoom Out
Zoom In

More Views

NOTE: If you are interested in Wireless Sensor Networks (WSN), M2M and the Internet of Things (IoT) projects check our new open source sensor platform: Waspmote which counts with more than 60 sensors available to use and a low consumption mode of just 0.07uA to ensure years of battery life. Know more at:

Details

This is a simple 4 cell AA battery holder. The 5 inch cable is terminated with a standard 5.5x2.1mm, center positive barrel jack connector.

The connector mates with the barrel jack on the Arduino (among a number of other products) allowing you to easily make your project battery powered.

Note: the average voltage regulator has about 1V of dropout (but can vary greatly). This pack, with normal alkaline batteries, will output ~5.5V causing a normal 5V board to run at around 4 to 4.5V. This depends a lot of what board and processor you are using with the battery pack. Please consult yer datasheet.

Additional Information

RoHS Yes

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.