NOTE: If you are interested in Wireless Sensor Networks (WSN), M2M and the Internet of Things (IoT) projects check our new sensor platform: Waspmote which counts with more than 60 sensors available to use and a low consumption mode of just 0.07uA to ensure years of battery life. Know more at:
Details
The CHIP QUIK® SMD Removal Kit is a quick and inexpensive way to remove SMD components from a PCB without a hot air station using only your soldering iron. The heart of the kit is a length of Chipquik low temperature alloy. This alloy is like a solder that melts at temperatures well below that of normal solder (136°F) and stays liquid long enough to melt the existing solder, allowing you time to carefully remove the component.
Simply apply a liberal amount of the included flux to the pins of the chip that you want to remove, then use a soldering iron with a flat-edge tip to heat the pins while applying the low temperature alloy. The alloy will remain liquid for a few seconds while you coat all of the connections, once you've coated the pins you should be able to lift the chip free using tweezers or a hemostat. Clean the pads thoroughly and apply fresh solder and you're ready to solder a new part in place.
Note: Solder wick comes in handy with this kit, so it might be a good idea to have some on hand. Check below if you don't already have some.
Kit Includes:
- 1 Tube of CHIP QUIK® Rework Paste Flux
- 2.5 ft. of CHIP QUIK® Low Temperature Alloy (Removes 8-10 Chips)
- Alcohol Prep Pads
Documents:
Additional Information
| RoHS | Yes |
|---|
You have no items in your shopping cart.
You have no items to compare.
